Make a Antenna Pan Bolic

We have already in the network without a cable that is Wireless, the network is already in legalkan by the government in 2005 .. and now for access to this network we need a hardware access point, WLAN, USB and wi-fi to work on the 2.4 Ghz frequency .. and when we kos-kosan near hotspot we only need one of the above hardware, kl-kos kosan us how much yah?, now we discuss about how to create a pan bolic antenna that is now rising again leaves. Bolic antenna pan memperhemat fund aims to buy from the grid or yagi antenna that was expensive, but can also pan bolic antenna is made for security mecrack course we ISP.kekeke directly to the topic that is the problem:

- Preparation: a ruler, solder, Bor, saw

- Material: USB Wi-fi, pan, Pipe 3 dim, dim light bulb 3 pairs of 2, Alumunium Foil, and Mur Baut, Double tape, Lakban, UTP 15 m cable, USB cable

now we start making,

first we measure the length of pan diameter, then measure the depth of melting .. we then calculated to determine the limit on the feeder pipe

The formula for the feeder: f = D ^ 2 / (16 * d)

once we know the limit on the feeder vent pipe we start with the pan for attaching a hubcap Bor pipe with bolts and later mur, on pipanya we lubangi that where we will install the USB wi-fi is, the formula for vent pipe and high-USB Wifi can be seen here.
after we've been following these steps then we start installing Alumunium Foil Pipe on the boundary with the feeder-free aluminum foil .. and do not forget a light bulb aluminum foil also be basically, well after the aluminum foil so we continue with the installation of pipes to pan after that last step in our modification UTP cable with a USB cable, for cable modifications can be seen in the picture